Steps for Doing a Central Heating Installation in Garland, TX
A heating system is a very important piece of appliance every homeowner should have. However a heating installation in Garland, TX is not as easy as you may think. It requires a good understanding of the process, proper planning and the right products. There is a possibility of doing basic installation of a central heating system on your own, such as installing the control system, selecting the boilers and radiators. However, there are other parts that require you to hire a professional, such as connecting the boiler to the gas supply, and also oversee that the heating system is safe and works properly. Below are the basic steps on what is involved in installing a heating system using a gas boiler.
Investigate the Options
The first step you should take if you're considering installing a heating system is to research in the equipment you will need. Choose a large enough furnace that is efficient to heat your home and supply hot water throughout your house. If you choose a boiler that is overly big then your monthly utility bill will go up due to heat loss from the boiler. Therefore, there is the need for proper research on the efficient boiler. Also research on the kind of radiator you will need, their specifications, not forgetting to get a control system that comes with clear instructions.
Plan on location of the installation
The next step is to draw up a plan on where the central heating installation will be. This will help when installing all the parts. Choose a spot that will allow for easy connection to water pipes and the gas boiler with proper ventilation as well.
Install the radiators
When doing radiator installation remember to keep the radiator 10-15 cm off the floor in order to keep some room for the valves and the pipes also allowing for cleaning. After that, install a wheel valve on the flow connection and a lock shield valve in the return connection. This will help to regulate the flow of water.
Attach radiator pipes and faucets to the boiler then install the control system
The next step would be to get copper pipes with capillary or compression joints. Be sure that the pipes properly vent the radiators so as to avoid the system from malfunctioning or getting air locks. After that look at the manufacturer's instructions and install the control system.
Install the gas boiler
This also requires you to follow the manufacturer's instructions carefully. It is also at this point that you will need the help of a certified contractor with the gas connection to the boiler. Be sure to hire a contractor for the job.
Activate
The last step is to close all radiator vents, fill the heating system with water then allows the radiators to vent through. This is done by switching on the boiler and balancing the heated water flow to each radiator by use of the lock shield valves. When this is done have your contractor determine the safety of the system.
Following the above steps for central heating installation in Garland, TX will ensure that the process is safe and your house is well heated. For the best installation, call our company to help with all your heating installation in Garland, TX needs.