6 Tips for Natural-Gas Furnace Installation in Garland, TX
If you are a homeowner who owns a furnace running on natural gas, having it replaced or repaired can be very expensive. Technically you can perform natural-gas furnace installation Garland, TX as long as you exercise maximum precaution measures. When you are working with gas it can be quite dangerous even with proper training. Working with this gas can be very volatile thus if you don't know how to work with it you should call a professional. However, if you do below are some of the tips you might need when doing your installation.
Do home assessment
The first step you need to take before doing the installation is carrying out an assessment for your house. This is to be sure that your old furnace is in working order or needs to be repaired or replaced. After you have done this you must choose the right size for your home's new furnace. When you’ve checked your furnace, be sure to check the ducts as well.
Turn your furnace off
The next step would be to then to shut the supply of gas and power to the furnace using the breaker and shut off valve. After that, you might need to secure the ducts with a screw. Ensure that your ductwork does not need to be replaced, then uninstall your current furnace to make space for the new installation. Be sure to memorize the wiring from your old furnace as it might help with wiring the new one.
Line up the furnace
The next step to natural-gas furnace installation is to line the new furnace up with the current gas valves and ductwork. After that is done you need to put on any doors wires, switches or latches needed in the internal furnace.
Connect the furnace
At this point, you are almost halfway through the job. What you need to do next is connect the ductwork that is coming off of the old furnace to the new one. Make sure the duct is properly attached to the natural-gas furnace. After you are done with that you can now attach the boot to the new furnace.
Install the natural-gas furnace
This is the final step of the process and it has various steps as well. First, you need to connect the gas line which is the tricky part. Use a gas leaker detector to determine if there are any gas leaks. Run the flue pipes to release any gas. Now you need to connect the thermostat and the power supply by wiring them which should look similar to the old wiring. Leave the room and come back after five minutes and check to see if you can smell gas. If there is none, you should be safe to turn it on. Remember to use the manufacturer's instructions to do this.
In conclusion trying out natural-gas furnace installation in Garland, TX can either go two ways. One it can either go bad or two it can be successful if you properly follow the aforementioned steps.